Posts in Category

Notions

Create your own fun and “Dazzling” Fruit Scrubbies in a few simple steps.

This project is perfect for keeping summer alive all year round and brings just the right pop of colour to your kitchen clean ups!

Materials:
– 2-4 balls of dishcloth or textured yarn* in colours: White, Yellow, Green, Red and/or Black
– 5.5mm (I-9) crochet hook
– 6 stitch markers
– scissors
*Gauge is not important for this project

Abbreviations:
ch = chain
dc = double crochet
st(s) = stitch(es)
sl st = slip stitch

Citrus Lemon & Lime Instructions

Round 1: With colour ‘White’, ch 4. Sl st in 1st ch, creating a loop. Work 8dc into the centre of the loop. Sl st in the 1st dc to close round.

* Switch to colour ‘Yellow’ (or ‘Green’ for Lime)
Round 2: Ch3 (counts as 1st dc), 1dc into same st, 2dc into each st in round. Sl st to top of ch3 to close round.

Round 3: Repeat Round 2.

Round 4: Ch3 (counts as 1st dc), 1dc into each st in round. Sl st to top of ch3 to close round.

* Switch to colour ‘White’
Round 5: Repeat Round 2.

* Switch to colour ’Yellow’ (or ‘Green’ for Lime)
Round 6: Repeat Round 4.

Finishing: Place 6 stitch markers equally around the edge of Round 5. With colour ‘White’, from the center, use surface slip sts between each round until you hit a marker. Repeat 5 times. Weave in all ends.

Watermelon Fun Instructions

Same pattern as ‘Citrus Lemon & Lime’.

Round 1-4: Use colour ‘Red’

Round 5: Use colour ‘White’

Round 6: Use colour ‘Green’

Finishing: With colour ‘Black’, sl st knots to create the seeds. Weave in all ends.

Download your own printable instructions PDF here.

Featured yarn used in this project is Spindle Yarns Dishcloth Dazzle.

Making this origami crossbody bag is easy and fun and oh-so-rewarding. Mix bag and lining fabrics to match all your outfits and add your own strap styles and embellishments to create extra personal touches.

It’s easy to adjust the size to make smaller as an evening bag or bigger for shopping … just be sure the rectangle size is length is 3 times longer than the width.

What You Need:
.3m of 150cm boiled wool fabric (or similar weight)
.3m of lining fabric (any width)
1.2m faux leather or other trim for the strap
2x triangle rings
2x swivel hooks

STEP 1:
Cut 1 piece each of the wool and the lining 36×12”. With right sides together, sew around all edges leaving a small opening.

STEP 2:
Turn right side out, press flat and edge stitch around the entire rectangle. Mark 14” on top and bottom edge as diagram and fold as shown.

STEP 3:
Fold sides towards the center along top and bottom points and pin. Machine stitch in place as far as possible along edgestitch end as shown. Hand stitch remaining opening to the point.

STEP 4:
Flip over and repeat. It will be trickier to sew the flap to the body on the 2nd side. Sew as far as you can and hand stitch remaining opening closed.

STEP 5:
Fold top of the bag tips over triangle ring bar and stitch in place as shown. Cut the strap to your preferred length, fold ends over swivel hooks as shown and stitch.

STEP 6:
Attach handle and add embellishments such as tassels or appliqués to personalize.

With the swivel hooks, it’s easy to make multiple straps to suit your mood or for an extra-easy version, just sew the strap trim directly to the corners of the bag.

Download your own instructions PDF here.

Looking for something to help decorate your home for autumn? Want to be creative and get the kids involved? This Felt Harvest Wreath is the perfect no-sew project!

SUPPLIES
• Wreath Ring
• Felt
• Fabric Of Your Choice
• Trim or Ribbon
• Scissors
• Fabric Glue

Step 1:
Cut out your leaves using the template provided or create your own!

Step 2:
For leaf shape #4 (see template), put a dab of glue on one end and pinch together until secure. This will give the leaf a more 3D effect.

Step 3:
Cut strips of fabric and wrap around your wreath frame. Secure with glue.

Step 4:
Wrap decorative ribbon or trim over the fabric. Secure with glue.

Step 5:
Layer leaves on top of the fabric and glue in place.

TIP: Use pins to map out placement of leaves before securing with glue.

Download project instructions and leaves template here.

If you’re a crocheter AND plant lover, this project is just for you! Create these cute plant holders for your mini succulent pots or other small plants. Hang them anywhere around your home or office and add some life into your living space!

Materials:

Super Bulky 6 or Jumbo 7 weight yarn
12mm crochet hook
1 stitch marker
measuring tape
scissors

Gauge:

6 sc x 7 rows = 4” (10 cm)
* This is only a recommended gauge used to fit a mini 3″ x 2.5″ (7.5cm x 6.5cm) clay pot, using a 12mm crochet hook, as suggested. It is to be used as a reference. You may use the recommended hook size found on the label. Just note, gauge and size of project will vary depending on the yarn and hook size chosen.

Abbreviations:

CH = chain
SC = single crochet
SL ST = slip stitch
ST(S) = stitch(es)

Round 1:

CH3, then close circle with a SL ST in the first CH. Make 1 SC in the middle of the circle, and then place a stitch marker on that ST. Make 5 more SC in the middle of the circle (Total of 6 STS)

Round 2:

Make 2 SC in the first ST. Place stitch marker on the first SC. Continue to make 2 SC in each ST. (Total of 12 STS)

Round 3:

*Make 1 SC in the first ST. Place stitch marker. Make 2 SC in the next; While keeping the stitch marker on the first ST, repeat from * to end of round. (Total of 18 STS)

Round 4:

*Make 1 SC in the first 2 STS. Place stitch marker on the first SC. Make 2 SC in the third ST; While keeping the stitch marker on the first ST, repeat from * to end of round. (Total of 24 STS)

Round 5-9:

Make 1 SC in each ST to end of round. Continue to place your stitch marker on the first SC of the round to keep track of each round. The edges will naturally begin to roll.

Round 10:

CH8, SL ST in the first ST, and continue to SL ST each ST to the end of round, including the CH. (Total of 32 STS)

Finishing:

Measure 8” (20cm) of your working yarn, cut. Wrap the tail end around the CH a few times. This will create the handle of your plant holder. Thread the tail end through all the wraps to keep it in place. Weave in all ends.

Download Printable PDF here.

Featured in this project is our Spindle Yarns “Mammoth”, available in-store.

Reduce your consumption of single use plastic with this Mesh Bag DIY! Simple to make and easy to wash; perfect for your next trip to the supermarket!

Step 1 – Cut a 40cm x 60cm rectangle of mesh. Increase or decrease the size based on the desired size of the bag.

Step 2 – Fold both side edges in 1cm and pin. Fold the top edge down 2cm and stitch 1.5cm from the fold to make a casing for the cord. Clip side edges just below the casing.

Step 3 – Fold the rectangle in half wrong sides together and stitch .5cm along side and bottom.

Step 4 – Turn right side in and hand press the seam. Stitch .5cm along side and bottom to make a french seam.

Step 5 – Turn right side out. Cut 55-60cm of cord. Attach a safety pin to one end and pull through the casing.

Step 6 – Add a cord stop and secure the ends with a knot.

Tip: Heat the ends of the cord with a lighter to stop fraying. * don’t try this with cotton cord!!!

Download instructions here

Jazz up your pup’s accessories with this adorable, functional and fun project. With so many trims to choose from you can create styles for every doggy personality … confident and classic, outgoing and sparkly or just laid back and casual; there’s a trim or embellishment for every look!

DIY dog collar examples

What you need:

  • ruler / measuring tape
  • fabric glue / needle & thread
  • scissors
  • webbing (1/2-1″ thickness)
  • D ring
  • parachute clip
  • slider
  • decorative trim
DIY dog collar supplies

What you do:

DIY dog collar instructions

Download instructions here

And why stop here … another great project for your furry friend is this super simple no-sew dog bed.

DIY dog bed and a cute dog named Sushi

Click here to learn how

Creating your own jewelry set for this year’s holiday or New Year’s party will not only make it special, but will allow you to co-ordinate with your outfit!

With the wide selection of chain, findings, beads and accessories available at your local Fabricland, you can create the exact jewelry piece you want.

Download a printable copy of the instructions here.

Check out this informative Beading Basics post filled with tips, tricks and knowledge!

Here’s a simple, yet fun project for some quick DIY decorations using felt and few notions!

Once you’ve got all your items together, cut out the pattern shapes.

Next, pin the shapes to the appropriately coloured felt.

Once pinned, cut out all the pieces.

  

Once cut, arrange all the pieces in preparation for gluing.

Glue down all the pieces of felt using a glue gun, or similar adhesive.

Decorate with sequin trim, google eyes or use your creativity to embelish your spooky shapes your own way!

  

Don’t they look spooktacular?! Decorate windows, walls and doorways using thread to hang or use them to add fun to your party’s snack table!

Download the pattern shapes here: Pumpkin | Ghost | Spider.

Fun With Felt

Let imaginations run wild with these cute felt Deer, Fox and Raccoon mask patterns.

Gather the materials you will need for this project.

Step 1:

Cut out all the shapes from the pattern. Pin your paper outlines to the appropriate colour felt and cut around.

Step 2:

Layer and glue the pieces of felt on top of one another. Using the picture reference as a guide.

Step 3:

To tie the mask, you will need to measure out approximately two 15” pieces of ribbon. Glue each piece (on the back side) near the edge of the mask, around where the middle of the eye cut outs are. Once all your glue has dried, try your new felt mask on! If the ribbon is too long after tying a bow, cut off any excess.
Download the printable PDF of patterns here.

Whether you’re off to the beach, the next soccer game or a picnic in the park, this Blanket Strap is a handy take-along for your blanket or towel. You could also use this as a stylish carry-all for your yoga mat! Make your own or as a gift and involve the kids in this simple project.

Download printable instructions PDF here.

With so many options for buckles & straps, you can have a stylish Blanket Strap for any occasion!

Share your DIY photos with #Fabricland50 …and show everyone your creativity!

1 2 3 4 Page 1 of 4