Crochet Mini Plant Holders DIY
If you’re a crocheter AND plant lover, this project is just for you! Create these cute plant holders for your mini succulent pots or other small plants. Hang them anywhere around your home or office and add some life into your living space!
Super Bulky 6 or Jumbo 7 weight yarn
12mm crochet hook
1 stitch marker
6 sc x 7 rows = 4” (10 cm)
* This is only a recommended gauge used to fit a mini 3″ x 2.5″ (7.5cm x 6.5cm) clay pot, using a 12mm crochet hook, as suggested. It is to be used as a reference. You may use the recommended hook size found on the label. Just note, gauge and size of project will vary depending on the yarn and hook size chosen.
CH = chain
SC = single crochet
SL ST = slip stitch
ST(S) = stitch(es)
CH3, then close circle with a SL ST in the first CH. Make 1 SC in the middle of the circle, and then place a stitch marker on that ST. Make 5 more SC in the middle of the circle (Total of 6 STS)
Make 2 SC in the first ST. Place stitch marker on the first SC. Continue to make 2 SC in each ST. (Total of 12 STS)
*Make 1 SC in the first ST. Place stitch marker. Make 2 SC in the next; While keeping the stitch marker on the first ST, repeat from * to end of round. (Total of 18 STS)
*Make 1 SC in the first 2 STS. Place stitch marker on the first SC. Make 2 SC in the third ST; While keeping the stitch marker on the first ST, repeat from * to end of round. (Total of 24 STS)
Make 1 SC in each ST to end of round. Continue to place your stitch marker on the first SC of the round to keep track of each round. The edges will naturally begin to roll.
CH8, SL ST in the first ST, and continue to SL ST each ST to the end of round, including the CH. (Total of 32 STS)
Measure 8” (20cm) of your working yarn, cut. Wrap the tail end around the CH a few times. This will create the handle of your plant holder. Thread the tail end through all the wraps to keep it in place. Weave in all ends.
Download Printable PDF here.
Featured in this project is our Spindle Yarns “Mammoth”, available in-store.